Silicone Mould - 25mm Circle Studs
These silicone moulds are designed for use with epoxy resin, however can be used with polymer clay, wax and concrete.
Cavity Thickness: 3mm
Mould Finish: Shiny
The moulds can withstand a heat of up to 230 degrees celsius. They should be stored on a level surface in a cool, dry place. Mould release spray can be used to increase the life of the mould. The best way to clean them is to lightly pick out glitter or excess resin with some sticky masking tape. Dish soap and warm water can also be used if necessary.
Using direct heat such as lighters and torches should be avoided as this can cause the resin to overheat and fuse to the mould.
This mould is perfect for all of the statement stud earring addicts. Whilst this mould does not come with jump ring holes, holes can be drilled into the resin after it has cured to turn them into dangle earrings.
Disclaimer: All measurements are approximate. As with all handmade silicone products, sometimes minor flaws can occur. Please note that these moulds are designed for epoxy resin and do NOT work with UV resin due to the fact that UV light cannot penetrate through coloured silicone.