Silicone Mould - Gingerbread Men, Sparkles, Stars and Mini Tree Christmas Stud Earrings

Sold Out
This product is unavailable

These silicone moulds are designed for use with epoxy resin, however can be used with polymer clay, wax and concrete.

Resin earring mould contains:

4 x 15mm Gingerbread Men Studs

4 x 15mm Sparkle Studs

4 x 15mm Star Studs

6 x 12mm Christmas Tree Stud

To care for your mould and prolong its life, store on a flat surface, protected from dust and away from direct sunlight. Do not hold a steady flame directly over the mould when using resin.

The moulds can withstand a heat of up to 230 degrees celsius. Mould release spray can be used to increase the life of the mould. The best way to clean them is to lightly pick out glitter or excess resin with some sticky masking tape. Dish soap and warm water can also be used if necessary. 

Disclaimer: All measurements are approximate. As with all handmade silicone products, sometimes minor flaws can occur. Please note that these moulds are designed for epoxy resin and do NOT work with UV resin due to the fact that UV light cannot penetrate through coloured silicone. 

Important Note - Do not use Barnes Clariti Resin in this mould. The corrosive bases in the Clariti Resin will cause the mould to corrode/lose its sheen very quickly and will significantly reduce the longevity of the mould.